You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 2017-11-19 05:42:22
- Yianni-VJ
- Member
- Registered: 2016-05-24
- Posts: 95
Speed μm/sec or mm/m?
The label in Resin Profile settings says μm/Second but I think the command sent to RAMPS is in mm/m
Can anybody confirm ?
Offline
#2 2017-11-19 09:47:24
- Shahin
- Administrator
- Registered: 2016-02-17
- Posts: 3,541
Re: Speed μm/sec or mm/m?
When you use those input values on gcode boxes, they get converted to mm. RAMPS default unit is mm.
Offline
Pages: 1