nanoDLP

Doug

Member

Registered: 2017-08-11

Posts: 100

Over Cure / Curing unwanted section

Hi do you know our have a clue why I'm getting this cured areas?

mkbot

Member

Registered: 2017-11-03

Posts: 24

Re: Over Cure / Curing unwanted section

Is your print over curing on the part itself too? I had an issue where I couldn't get the included sample resin dialled in at all. Either there was something wrong with it, or there's an issue related to the brightness of the LED. Still trying to sort out the latter at the moment. Though in my case, other resins worked much better right off the bat.