nanoDLP

szedmeg

Member

Registered: 2017-09-26

Posts: 7

Stepper motors not move if printing start.

Hi guys,

I have a little problem with the stepper motor. (pi3 + Ramps 1.4 + Marlin 1.1)

When i use it via Configuration page, it's work fine. But when print start it's not move.

I think the movement code is sent by the pi just my ramps can not process it.

Is the marlin firmware not configured properly?

Or else do i have to use config?

Thank youu

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: Stepper motors not move if printing start.

You need to use patched marlin firmware as the most of available gcode config available on net for nanodlp, requires patched firmwares.