nanoDLP

Xmike

Member

Registered: 2016-03-25

Posts: 97

Some Issues

Hi Shahin,

I have multiple problems in Build 1151 and Build 1155.
Build 1151:
1 ) In the menu "Printer Profile" -> "Mask File" , the options "Use if Available" and "Ignore" are selectable.
     If I select "Ignore", then after saving still appears only "Use , if Available".
2 ) When I stop the print and afterwards continues with "Resume Print", then there appears a Messgebox
     "Are you sure ... print from Layer X ?".
     Depending on whether "Resume Print" from the main page or from "Plates" will be startet,
     a different layer number appears.
3) After installing Build 1155 my printer doesn't work anymore.
    I can not move the axis, neither with "Z Axis Calibration" nor with a manual GCode.
    When I type a command  in the GCode window, in the Terminal does nothing appear.
    When I again restore the previous version (Build 1151) then the printer works again.

Last edited by Xmike (2016-05-03 20:28:47)

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: Some Issues

Hi,

1) Fixed, thanks. Will push the new version later.
2) Plate page is static, you need to refresh this page to get latest layer id, if the plate page is opened before stop. Number could be wrong but refreshing page will fix the issue.
3) Are you sure about build numbers? Not much changed since 1151, lots changed on 1151 itself but nothing important or related to gcode afterwards.

Xmike

Member

Registered: 2016-03-25

Posts: 97

Re: Some Issues

Hi Shahin,

2) Please have a look on the Layer numbers in the Messageboxes (Build 1151):

3) Build 1155
    The only GCode that appears in the terminal is the Bootup - code otherwise no movement is possible .

Last edited by Xmike (2016-05-04 17:21:16)

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: Some Issues

Mike,

Thank you for the awesome gifs.

Both issue has been fixed and beta version updated.