nanoDLP

mattcaron

Member

From: Galway, NY, USA

Registered: 2016-02-19

Posts: 21

Website

Set a default print profile / set profile order

Use case:

As a general case, one has one type of resin in one's vat for a reasonable period of time, and one is using one X/Y/Z resolution for some amount of time. Therefore, when adding plates, it would be nice to not have to pick the current one you are using from the drop down every single time. It would be more convenient to set the default when you set up the printer, and then this will be the default selection when adding plates.

Thanks.

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: Set a default print profile / set profile order

Available on the beta version.