nanoDLP

maatd

Member

Registered: 2017-08-28

Posts: 11

32bit ARM version - display

Hi

Does anyone have much experience setting up NanoDLP on an ARM board like Orange Pi or Banana Pi using the portable ARM version.

I've got it all running fine, but doesn't exit console and turn screen (which ever screen I use) blank as with set up like RPi. Every command given via the interface is just listed in the console.

Last edited by maatd (2017-10-18 01:36:07)

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: 32bit ARM version - display

If you are using nanodlp without desktop environment. You should fill framebuffer field on the setup page. (usually /dev/fb0)
I am not sure if I have published ARM for linux desktop but for such version you need to press start button on dashboard to use opengl backend.

maatd

Member

Registered: 2017-08-28

Posts: 11

Re: 32bit ARM version - display

Thanks, I'll take a look - yes, running from command line in Armbian without desktop environment.

goose

Member

Registered: 2017-12-04

Posts: 1

Re: 32bit ARM version - display

Hi maatd,

Did you manage to get it working?

regards,
Gerard

maatd

Member

Registered: 2017-08-28

Posts: 11

Re: 32bit ARM version - display

I shelved it - and ordered an RPi, wasn't worth the frustration in the end - just keen to get on with printing