nanoDLP

MaxJewels

Member

Registered: 2017-08-10

Posts: 88

Sound at the end of printing

You can activate the sound at the end of printing with GPio

MaxJewels

Member

Registered: 2017-08-10

Posts: 88

Re: Sound at the end of printing

The GPIO is used in event observation, mode with the callback function on Sound Event that is activated by a trigger whenever the GPIO input changes its condition. Because there are many high/low transitions in a single sound incident, the event registration is deactivated by putting the callback process to sleep .

However, you can put GPIO "x" high for "x" seconds when printing is finished

Last edited by MaxJewels (2017-10-04 10:56:22)