nanoDLP

bread

Member

Registered: 2017-09-28

Posts: 2

imported model automatic height to 5 mm.

When I add a model it automatically get set to 5mm height. ( move = 5 )
see screenshot: https://prnt.sc/gqovme

Is this normal? I have latest nanodlp build with wanhao 7 settings.
Where do I change it? Can't find the code.

This is problematic for me because it often resets the height to 5 and then when you print it prints empty space.

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: imported model automatic height to 5 mm.

If you already put supports on the model, do not use 3d editor and directly add STL mode.
Alternative you can put zero instead of 5 in 3d editor so all models will stick to the floor.