You are not logged in.
Pages: 1
Hi everyone,
First of all i am using nanodlp windows
I am planning to use nanodlp to control an LCD SLA printer. I've got my ramps and motor setup but i am struggling to get the LCD working. I connected an HDMI monitor to my laptop HDMI port. Without changing any setting i tried to press "Start Display" but my main display turned blank and the HDMI monitor didn't receive any signal. As soon as i pressed "escape" on my laptop nanodlp crashed (stopped responding) .
I have noticed that in the setup page there are display settings but apart from the resolution i dint understand the others. Communication type ? Turn on/off command? usb serial port address?.
Could anyone enlighten me on display setting and how to get the HDMI display to work as the printer display?
Has anyone been able to get the display working using windows version?
Thanks
Offline
rickzug1, does your second monitor show anything when connected? in windows i mean? as in extended desktop for example?
Offline
The second screen is completely dark and the power light flashes as if it was connected to a powered off PC.
Offline
could you possibly duplicate the display in windows settings and see if both screens turn on?
i had an issue to fire up my lcd when connected directly to my laptop. only when i duplicate the screen it turned on.
so see if this could guide you in the right direction?
Offline
Did you have any luck with this? I have the same issue with my projector using the windows version, I only get the entire desktop displayed in my projector not the slices. And when I press display start I too get a blank screen.
Offline
I am having same issue what @zpapadelias is having. Any success on it tried primary & secondary nothing works
Offline
Pages: 1