nanoDLP

Rigra

Member

Registered: 2017-08-20

Posts: 10

complete layer in a hollow model.

Hi, I'm runinng build 1589. I uploaded an STL hollowed and supported in meshmixer, and when I slice it in NanoDLP, noticed something stange from layer 369 to 397 the model apears solid, and then it becomes hollow again. I double check the STL, and the geometry is completly hollow, so I don't understand why this is happening. Am I missing some settings that create this wall?

Layer 366 Hollow:

Layer 397 Solid:

Layer 400 Hollow Again:

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: complete layer in a hollow model.

Try netfabb, maybe there is shell. If netfabb does not found any issue, I need STL file to checkout logic.

Rigra

Member

Registered: 2017-08-20

Posts: 10

Re: complete layer in a hollow model.

ok, I have to install netfabb, I'll doit in the weekend and then report my results.
Thanxs