nanoDLP

g713

Member

Registered: 2017-09-05

Posts: 3

D7 LCD not functioning.

The LCD works when using the D7 software. When using NanoDLP the light come on and the LCD just turns on (BLACK) then goes off.. I can't get any of the calibrations to work.

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: D7 LCD not functioning.

You need patched firmware as there is command to turn lcd on and etc. Follow guide below.
https://3dprinterwiki.info/d7/d7-nanodlp-settings-2/

g713

Member

Registered: 2017-09-05

Posts: 3

Re: D7 LCD not functioning.

I have tried that with no luck. But I will try again.

WheresWaldo

Member

Registered: 2017-05-17

Posts: 37

Re: D7 LCD not functioning.

@g713 Make sure you use the D7 specifically modified firmware, not just any modified firmware. See the D7 Facebook group or the wiki pages for this.
https://3dprinterwiki.info/wiki/wanhao- … ll-option/

Last edited by WheresWaldo (2017-09-05 14:16:40)