nanoDLP

CustomCreations

Member

Registered: 2017-06-16

Posts: 12

Support Undercut and release tab

I saw that FormLabs has an undercut and release tab in their base support to aid in removal of the print very easily. I think this would be a great addition!

https://support.formlabs.com/hc/en-us/a … hing-Steps

macdarren

Member

Registered: 2017-03-20

Posts: 411

Re: Support Undercut and release tab

I agree some sort of lift tap maybe on the corners or sides of the Unified Support Base you generate with the support system.

Alternately since I often use a large scrapper maybe one whole side of the unified support could have a step or ledge...