nanoDLP

Pyper

Member

Registered: 2017-06-01

Posts: 13

Z axis moves under calibration, but not during print

My Z axis stepper motor moves correctly under the calibration tab, but does not move at all when printing.

Could this be a resin profile problem?

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: Z axis moves under calibration, but not during print

If you are using RAMPS, yes it is gcode issue.

Pyper

Member

Registered: 2017-06-01

Posts: 13

Re: Z axis moves under calibration, but not during print

I cannot get the z axis stepper motor to change speed.
It only moves at a very slow rate.
Even if I use a direct g code in the terminal, like:
G1 Z-250 F700
It just creeps along barely moving and should go much faster
?

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: Z axis moves under calibration, but not during print

Pyper,
If you are using RAMPS, you need to check firmware settings on RAMPS side.