nanoDLP

luojun163

Member

Registered: 2023-12-19

Posts: 0

How to use this variables "Boundary - X"

Please tell me，How to use this variables "Boundary - X" ?
I want to use this variables in "Code Before Each Layer”，please How？

e.g.：
Layer    1/1162
Area Count    2
Layer Thickness
Total Solid Area    0.0785834
Largest Area    0.04043968
Smallest Area    0.03814372
Boundary - X    841 - 846
Boundary - Y    1097 - 1463
Special
Code Before
G1 Z0.025 F60.0000 P1
COMMAND - Waiting until receive Z_move_comp from shield
COMMAND - Set position to 0.025
COMMAND - Delay print for 0.5 seconds
M106 S255
Wait Before Cure    0.000000
Cure Time    110.000000
Code During Cure
Wait After Cure    0.000000
Code After    M107
COMMAND - Delay print for 0.5 seconds
G1 Z7.0250 F20 P1
COMMAND - Waiting until receive Z_move_comp from shield
COMMAND - Change position 7
Wait After Lift    0.500000