You are not logged in.

#1 2017-05-14 10:53:58

Bixx
Member
Registered: 2017-05-14
Posts: 7

Anaylzing STL file

Hi, first post.

I have searched the forum and cannot find how to stop an stl from being anyalyzed.
It has been going for 2hrs+
I have switched off the Pi3, restarted both nanodlp and the Pi3 but each time it it goes back to 'analyzing stl file'.
I have even tried deleting the plate, but still it continues.

Is there a way to do this?

many thanks

Bixx

Offline

#2 2017-05-15 18:40:02

Shahin
Administrator
Registered: 2016-02-17
Posts: 3,536

Re: Anaylzing STL file

You can remove STL source file. I will try find solution to this problem.

Offline

#3 2017-05-15 20:42:21

Bixx
Member
Registered: 2017-05-14
Posts: 7

Re: Anaylzing STL file

Thanks for the suggestion. I somehow managed it after about 5hrs. A kill  switch would be nice to stop it restarting automatically.

Last edited by Bixx (2017-05-15 20:43:25)

Offline

Board footer

Powered by FluxBB