nanoDLP

macdarren

Member

Registered: 2017-03-20

Posts: 411

New Time to Print wrong units?

The times given in the plate view after a print completes (which I am glad this was added, thanks) seem to indicate
minutes as the unit of time which would probably be a good unit...I think it should maybe it is being given as seconds..a print that took a few hours shows as 12682m
If reporting to the second which is nice, could we maybe get H:M:S format?

Thanks again for the feature.

Darren

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: New Time to Print wrong units?

Done