Distro/change button question

color · 2016-03-29 18:17:42

Hello, It seems the "Change to mUVe3D" button not working. After pressing the button, nothing happened and in setup page I can't see the mUVe default settings. In printer proffile I have "Mcast +sylgard, etc" I have a fresh SD image installed on Rpi3

Shahin · 2016-03-29 18:32:58

Please, run following command from terminal and restart. let me know if it is working.

sudo cp -f /home/pi/printer/distro/muve3d/opt/db/* /home/pi/printer/db/

color · 2016-03-29 19:23:33

Yes, this work. Is it necessary to do this every time after reboot or this setting will be remembered?

Shahin · 2016-03-29 20:04:21

it will be remembered.

color · 2016-03-29 20:45:20

Thank you for the support, Shahin.

nanoDLP

#1 2016-03-29 18:17:42

Distro/change button question

#2 2016-03-29 18:32:58

Re: Distro/change button question

#3 2016-03-29 19:23:33

Re: Distro/change button question

#4 2016-03-29 20:04:21

Re: Distro/change button question

#5 2016-03-29 20:45:20

Re: Distro/change button question

Board footer