nanoDLP

Xmike

Member

Registered: 2016-03-25

Posts: 97

positioning mode

Hallo Shahin,
is for "position recovery"  the absolute positioning mode (G90) required or can the relatieve positioning (G91) also be used,
are there any disadvantages with use of relatieve positioning.
In my self built printer I use a arduio with ramps board and Repetier-firmware, have I also to use the
[[WaitForDoneMessage]] to control movement ?

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: positioning mode

To set position on RAMPS absolute positioning is required.
But more movements, they do not have any difference.

You need to patch your firmware. Currently you can use patched marlin and grbl firmwares.