You are not logged in.

#1 2022-06-24 05:04:09

peaceblackhair
Member
Registered: 2018-12-11
Posts: 42

Slicer issue filled the insides with white

Hello Shahin,

i decided to upgrade my nanodlp from 4550 to 5749 and i got some slicing issues, new versions fill white the inside of some contours

Slicing result of version 5749
v5749

Same stl slicing result of version 4550
v4550

for version 5839 beta same result as 5749. I had this issue for a lot of different stls.

And also how can i get version between from 4550 to 5749 for try this problem ?

Last edited by peaceblackhair (2022-06-24 05:05:22)

Offline

#2 2022-06-24 06:00:57

Shahin
Administrator
Registered: 2016-02-17
Posts: 3,517

Re: Slicer issue filled the insides with white

As far as I can tell not much changed recently on slicer.
I assume one of the small adjustments to detect filled area causing this. Interpretation of faulty mesh structures could be different with each parameter changes.

If it is possible share source STL file to find out cause of the issue.

Offline

Board footer

Powered by FluxBB