Raspberry pi 3 and DRV8825

mandreas · 2016-03-20 00:23:42

behold,

all the pieces for my printer "top down" arrived, now comes the fun part ... connect the Raspberry pi 3 and DRV8825, the stepper motor has 40 steps to make one millimeter,
any advice for cable connections ?

Shahin · 2016-03-20 00:28:09

Wiring will be exactly like this

mandreas · 2016-03-20 00:40:41

Thanks Shahin,

this is the concept render of my "baby"

Rastati · 2016-03-20 20:00:49

Hey Mandreas, be sure to check this link from Pololu to set up the DRV8825 VREF voltage:

https://www.pololu.com/product/2133/faqs

Might save you some trouble!

mandreas · 2016-04-22 19:21:05

thanks @ Rastati,

I read your message only now, very welcome,

I'm stuck in the advancement due to incoming fuses from china .... (I do not think it was so hard to find fuse 24 volt 2 amps ..)

nanoDLP

#1 2016-03-20 00:23:42

Raspberry pi 3 and DRV8825

#2 2016-03-20 00:28:09

Re: Raspberry pi 3 and DRV8825

#3 2016-03-20 00:40:41

Re: Raspberry pi 3 and DRV8825

#4 2016-03-20 20:00:49

Re: Raspberry pi 3 and DRV8825

#5 2016-04-22 19:21:05

Re: Raspberry pi 3 and DRV8825

Board footer