You are not logged in.
- Topics: Active | Unanswered
#1 2021-10-23 03:47:37
- haipham
- Member
- Registered: 2017-05-05
- Posts: 20
Nanosupport - How to slice from PC to my rasberry pi on same network
My nano support found my raspberry Pi address, but how to slice direct to my printer, because my file is large and i want to use strong of my PC
Offline
#2 2021-10-25 09:07:17
- Shahin
- Administrator
- Registered: 2016-02-17
- Posts: 3,541
Re: Nanosupport - How to slice from PC to my rasberry pi on same network
When you press send, it locally (on your PC) slice then send it to nanodlp.
Offline
#3 2021-10-26 03:46:43
- haipham
- Member
- Registered: 2017-05-05
- Posts: 20
Re: Nanosupport - How to slice from PC to my rasberry pi on same network
Shahin wrote:
When you press send, it locally (on your PC) slice then send it to nanodlp.
when software found printer, slice and send button is disable, what's problem? Seem to sofware cant connect to printer
Offline
#4 2021-10-27 05:34:12
- Shahin
- Administrator
- Registered: 2016-02-17
- Posts: 3,541
Re: Nanosupport - How to slice from PC to my rasberry pi on same network
You need to choose resin profile on nanosupport. Make sure you have resin profile available.
Offline
#5 2021-11-07 02:50:52
- haipham
- Member
- Registered: 2017-05-05
- Posts: 20
Re: Nanosupport - How to slice from PC to my rasberry pi on same network
Shahin wrote:
You need to choose resin profile on nanosupport. Make sure you have resin profile available.
no resin profiles show in nano support, i dont know why
Offline