You are not logged in.

#1 2021-10-19 10:39:28

mariopi
Member
Registered: 2021-10-19
Posts: 3

phrozen suffle XL 2018 do not move in printing

I have installed nanodlp in phrozen shuffles 2015, the movements with hmi display are correct, test inLCD is correct too, but when i goes to print not move, allways is in the same position, what is doing bad?

i use all components only upgrade HMI from 3.5 to 4.3 inches

nanodlp last stable version

Last edited by mariopi (2021-10-19 10:42:41)

Offline

#2 2021-10-21 05:17:12

Shahin
Administrator
Registered: 2016-02-17
Posts: 3,518

Re: phrozen suffle XL 2018 do not move in printing

Probably firmware is not synchronizing. Is the manual movement works?

Offline

#3 2021-10-22 14:48:44

mariopi
Member
Registered: 2021-10-19
Posts: 3

Re: phrozen suffle XL 2018 do not move in printing

yes it works, manual move, homing etc, only not move in layers

Offline

#4 2021-10-25 09:06:47

Shahin
Administrator
Registered: 2016-02-17
Posts: 3,518

Re: phrozen suffle XL 2018 do not move in printing

OK, it is surely synchronization issue
https://docs.nanodlp.com/manual/code/#synchronization

Offline

#5 2021-10-31 23:11:35

mariopi
Member
Registered: 2021-10-19
Posts: 3

Re: phrozen suffle XL 2018 do not move in printing

solved, was a problem with Z min sensor, not move axis when print and when program layer movements in resin parameters this are inverted

Offline

Board footer

Powered by FluxBB