nanoDLP

fran42

Member

Registered: 2020-11-16

Posts: 70

Change the exposure time depending on the layer

In order to use the 3D printer to create microfluidic channels, would be a very good option if the exposure time could be variable depending on the layer.

Is there any way to program that in nanoDLP?

Regards

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: Change the exposure time depending on the layer

You can do it using dynamic cure-time field

elliot

Member

Registered: 2016-04-28

Posts: 109

Re: Change the exposure time depending on the layer

Hi Fran,
If you are interested, I do microfluidic 3D printing with resolutions down to 5.5 um (2.5 with a special optic). I would be very interested to talk some and see if there is a collaborative interest.

Best regards,
Elliot

fran42

Member

Registered: 2020-11-16

Posts: 70

Re: Change the exposure time depending on the layer

Hi Elliot,

Sure we can talk about what are we doing and see if there is any possibility for a collaboration!

Best Regards

elliot

Member

Registered: 2016-04-28

Posts: 109

Re: Change the exposure time depending on the layer

Hi Fran, please check out www.skyphos.tech