nanoDLP

Kuber

Member

Registered: 2021-08-18

Posts: 1

several z-axis motors

Good morning, I have a few, I want to build a very large dlp printer, i.e. with a display size of about 1200x650 mm, to lift the table in the z axis, I would need a few stepper motors, how can I adapt it to nanodlp. There will be 4 motors on the z axis, I would like each of them to have an inductive sensor and align to it, so that I would know that the table is always evenly lifted from zero. Thank you in advance for your help if I wrote something not clear, please ask, I will try to explain

Doug

Member

Registered: 2017-08-11

Posts: 100

Re: several z-axis motors

you need to set your firmware to do that, put all motors you need in Z.
Dont change anything in nanodlp