You are not logged in.

#1 2021-07-07 12:04:41

PropellerHat
Member
Registered: 2019-07-23
Posts: 35

have you changed your movement settings from the default?

Hi

I am curious to hear what builds are people running after succesfully changing the settings such as lead screw pitch or micro stepping.

If you have changed some of the movement settings from the defaults, please tell me what build of Nanodlp are you using.

Thanks!

Offline

#2 2021-07-22 09:49:21

Shahin
Administrator
Registered: 2016-02-17
Posts: 3,518

Re: have you changed your movement settings from the default?

It depends on kind of configuration you are using. Let me know kind of hardware you are using RAMPS or Direct control?

Offline

#3 2021-07-22 11:53:38

PropellerHat
Member
Registered: 2019-07-23
Posts: 35

Re: have you changed your movement settings from the default?

I use the controller board.

No need for Ramps, right?

I used to use direct control on the previous version of the printer but the axis movement was impossibly bad.

Offline

#4 2021-07-24 06:29:50

Shahin
Administrator
Registered: 2016-02-17
Posts: 3,518

Re: have you changed your movement settings from the default?

Controller board is kind of RAMPS. You need to define / change settings on RAMPS side too. It is where mm being converted to pulses.
https://docs.nanodlp.com/guide/controll … xis-height

Offline

Board footer

Powered by FluxBB