You are not logged in.

#1 2017-01-11 15:16:50

goldcoast
Member
Registered: 2017-01-11
Posts: 2

[solved] Build 1322 z issue

Hello everybody,

First thank you to the programmers for this great software
Recently updated to the version 1322 and got problems on the z axis.
My config:
Bottom up printer
I am using gpio.
my Lift After Print are set to 0.2mm
Layer Thickness 30um

but got unrealistic values after updating to the last version(didn't change any setting form my previous release), like down 14.89 and up 14.72 instead of  up 0.2  and down 0.17, and finaly hit the vat

Debug    259    2017-01-11 15:12:21.329903    Pulsing    Movement Finished Pulse 5888 / 5888 ; Height 62744 / 56856 ; Time 26.038986069
Debug    259    2017-01-11 15:11:55.29065            Pulsing    Moving Up 5888 pulses 14.72 mm
Debug    259    2017-01-11 15:11:55.290458    Pulsing    Movement Finished Pulse 5956 / 5956 ; Height 56788 / 62744 ; Time 7.213137565
Debug    259    2017-01-11 15:11:48.077007    Pulsing    Moving Down 5956 pulses 14.89 mm
Debug    259    2017-01-11 15:11:48.076757    Pulsing    Moving to Layer
Debug    258    2017-01-11 15:11:47.758522    Pulsing    Movement Finished Pulse 80 / 80 ; Height 56868 / 56788 ; Time 0.392769806

Thank you for your help

Last edited by goldcoast (2017-01-12 11:13:12)

Offline

#2 2017-01-12 09:03:33

Shahin
Administrator
Registered: 2016-02-17
Posts: 3,536

Re: [solved] Build 1322 z issue

Hi,

Please, try latest version and let me know if the issue goes away. I could reproduce the issue.

Offline

#3 2017-01-12 11:12:13

goldcoast
Member
Registered: 2017-01-11
Posts: 2

Re: [solved] Build 1322 z issue

Shahin wrote:

Hi,

Please, try latest version and let me know if the issue goes away. I could reproduce the issue.

Thank you very much Shahin, it works like a charm now wink

Offline

Board footer

Powered by FluxBB