nanoDLP

spika

Member

Registered: 2019-05-18

Posts: 4

GCode in Dynamic formulas

Good day, ladies and gentlemen.
I ask the knowledgeable for help. I have DLP from bottom to top, an actuator is used to lift the bath.
I figured out how to use dynamic time.

[[Delay {((([[LayerNumber]] <= 4) * 29)) + ((([[LayerNumber]]> = 5) * 6))}]] - works
And how to insert GCode into the knowledge formula is not enough.

         GCode ([[LayerNumber]] <= 4), GCode ([[LayerNumber]]> = 5) ????
Dynamic speed (bath tilt control)
if ([[LayerNumber]] <= 4) use GCode1
or ([[LayerNumber]]> = 5) use GCode2

Thanks everyone.

Last edited by spika (2021-06-10 20:46:51)