You are not logged in.

#1 2021-05-10 16:36:27

nleven584
Member
Registered: 2021-05-10
Posts: 4

CM4 with IO board nanodlp install on Muve3D

I've installed the latest nanodlp build on a CM4 module with the rasp pi IO board. The nanodlp interface and ethernet connection works and after activating the USB I can get connection to the z-axis/microcontroller, but the GPIO pin out to the shutter won't respond and neither will the HDMI. Is there additional lines of code I need to uncomment?

Offline

Board footer

Powered by FluxBB