nanoDLP

yaoalen

Member

Registered: 2019-02-10

Posts: 2

Z Model Size Modifier

When I use a certain type of resin to print, the height of the object is not enough. Can I use the setting page of the resin to change the height after printing?
The height of the object should be 3MM, but only 2.9MM after printing,
I found this field in the setting page of the resin(Z Model Size Modifier (Percentage)), how do I enter it?

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: Z Model Size Modifier

I think it is calibration issue.