nanoDLP

venice0926

Member

Registered: 2016-08-12

Posts: 13

Need Help:Z step motor Max only 250mm??

Dear Administrator:

    I try to move Z step motor. It can be move to 250 mm.If it move more then 250 mm,it can't move. Z step motor must to down,and down to 250 mm, It can be move.

======================================
0 mm ~ 250 mm  -->  Z step motor (Move)
250 mm ~ 500 mm  --> Z step motor (NOT Move)
500 mm ~ MAX mm --> Z step motor (NOT Move)
======================================

ps:photo link:
https://drive.google.com/file/d/0B8qROt … sp=sharing

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: Need Help:Z step motor Max only 250mm??

If you are using RAMPS, it could be limit compiled in your firmware.
Error which you have highlighted is normal. RAMPS using mm or inch unit. But movements are all converted to smallest pulse unit so 250mm could be something else. On nanodlp side we try to make sure no error albeit small raise because of these unit changes.

venice0926

Member

Registered: 2016-08-12

Posts: 13

Re: Need Help:Z step motor Max only 250mm??

Hi

I use marlin file and import to RAMPS. Marlin file name is "Marlin-mUVe1DLP-Running-master.zip".

venice0926

Member

Registered: 2016-08-12

Posts: 13

Re: Need Help:Z step motor Max only 250mm??

hi Shahi:
I find the answer.Marlin file have a item,this item name is "Z_MAX_POS".

THANKS.