nanoDLP

andy

Member

Registered: 2021-03-10

Posts: 1

phrozen make xl

Hi all,

Just seeing if I can make this, now old, printer work well again.

I'm going to open it up tomorrow to check the boards and make a backup of the pi image.
I think I've found the correct Phrozen image for it but was wondering

1)Has anyone got this working with latest rasbian/ nano dlp please.

2) do we know the ssh username/ password for it?

3) there's little information I can find on this printer nowdays.
For resin profiles is there some similar printer to use the profiles for
E.g. use the shuffle ones and I should be close?

I'm new to resin (comfortable on fdm and linux/ pis) so am just working out the calibration steps now.

Many thanks and hello!

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: phrozen make xl

Hi,

1. I guess so, even non-nanodlp transformer could run NanoDLP without any hardware modification.

You probably could find profile and other details on Phrozen Transformer group on facebook.