nanoDLP

sinned6915

Member

Registered: 2019-08-22

Posts: 52

Issues with Dynamic Cure times, Remote Slicing 4334

Dynamic Cure times and remote slicing are not working correctly in 4334. I verified that PC is at build level 4334 as well.

Remote slicing just seems to hang at the raspi end. There is no output in the commnad terminal on the remote side like there used to be. Disabling remote slicing, the model will slice on the raspi.

Dynamic cure: I do not know why the first value in the reported cure times is 10 when the series starts with 11.5 and is 5 times.

Deleting the plate and redefining it is of no sucess.

binfordboy

Member

Registered: 2017-02-28

Posts: 54

Re: Issues with Dynamic Cure times, Remote Slicing 4334

When printing in multiple print mode the original profil cure time is also added to the additional ones specified in the "Multiple Print" Textfield.

Remote slicing with 4334 is fine by me - maybe some network hickup?

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: Issues with Dynamic Cure times, Remote Slicing 4334

I also could not reproduce it locally.

sinned6915

Member

Registered: 2019-08-22

Posts: 52

Re: Issues with Dynamic Cure times, Remote Slicing 4334

When printing in multiple print mode the original profil cure time is also added to the additional ones specified in the "Multiple Print" Textfield.

that is what appears to be doing. is this by design?

remote slicing- PC and raspi are literally on the same switch and subnet. I can not figure it out.

binfordboy

Member

Registered: 2017-02-28

Posts: 54

Re: Issues with Dynamic Cure times, Remote Slicing 4334

that is what appears to be doing. is this by design?

Yes, just click on the tiny info Button above the "Multiple Print" Textfield, it's explained there.