nanoDLP

SimpleRapid

Member

Registered: 2016-09-30

Posts: 16

Does not print anything

Hello everyone,

I think I have correctly configured the electronics (I use Grbl) when calibrating the Z axis, it moves correctly. It moves very well.
When I turn on the projector it also lights up correctly.

But it does not work when I try to print something.

Can somebody help me.? I can not find the answer in the forum.

Thank you very much.

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: Does not print anything

You can fix your issue following this thread http://www.nanodlp.com/forum/viewtopic.php?id=116

manojd

Member

Registered: 2016-11-11

Posts: 23

Re: Does not print anything

I had the same issue. Problem was with the "Waitfordonemessage" commands in gcode. The grbl 0.8c that I am using does not seem to be compatible with the RAMPs sync module in nanodlp. Remove those commands and see if it works. You may want to put a delay instead.

SimpleRapid

Member

Registered: 2016-09-30

Posts: 16

Re: Does not print anything

Thanks for your answer. I use Grbl version 0.9.