nanoDLP

mogey336

Member

Registered: 2019-07-04

Posts: 17

Z axis direction

I'm using NanoDLP Shield V1.1 with one Bottom Limit and i disabled the top limit in the setup page.
when i click floor 50 mm it moves down until the limit bottom switch but when i click on the floor down it moves up!
When i click Top up it moves down to the bottom limit switch.
My axis moves correct if i click floor 50mm or top 50mm but reversed on limit bottom and top up icons

Catalin

Member

Registered: 2021-06-10

Posts: 6

Re: Z axis direction

Be sure to be in relative positioning (Type G91 in the terminal or use the G91 command in bootup code).

Otherwise, the default state is Absolute positioning. If you click on 50mm up or down, it will just go to the 50mm position, from its current position.