nanoDLP

Wombat

Member

Registered: 2021-01-10

Posts: 17

3D Editor black

Hi,

I just installed buid 4239. Everything works fine except the 3D editor. I can see all the buttons but the preview always stays black. When I upload models, they appear in the right-hand list but not in the preview. In addition, I can no longer exit the 3D editor. When I click on Exit, nothing happens.
Is this a known problem?

Wombat

Member

Registered: 2021-01-10

Posts: 17

Re: 3D Editor black

Addendum: One more thing irritates me. In the plate area I get the message that the free space on the disc is almost empty. But that can't be, it has 16 GB and I have only created one plate.
The plate I created worked reasonably well. The 2D layers look good and the small preview image was created successfully. But the loading bar still says: "The plate is not sliced yet", although everything has long since been sliced. Are the problems perhaps related?

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: 3D Editor black

1. 3D editor issue probably related to your browser settings which somehow prevent webgl runs
2. Maybe you have not expanded disc to make all space available, check total space being reported by nanodlp
3. It is expected to have the plate is not sliced for couple of seconds upto few minutes. It means it generated but not verified by nanodlp. Process decode each layer and check possible issues with them.

Wombat

Member

Registered: 2021-01-10

Posts: 17

Re: 3D Editor black

Sorry for my late reply, had to wait for the weekend to spend more time on this.
Thank you so much for your answer, that helped a lot! Just had to eneble webgl in Chrome and press the "expand filesystem" button in nanoDLP/Settings/Tools.
))