nanoDLP

mogey336

Member

Registered: 2019-07-04

Posts: 17

Z axis steps per mm

I'm configuring my Z axis now, I have ball screw SFU1204.
I set my pitch to 4 mm and motor to 1.8 with micro stepping 32.
I build many FDM printers so i know steps per mm are very important value
Is this the only configuring without steps per mm.
I'm using nanoDLP Shield v1.1

bigfilsing

Member

Registered: 2016-11-20

Posts: 306

Re: Z axis steps per mm

The main difference is here ( from FDM) you are configuring pitch not steps per mm
If nano knows your pitch , step angle & micro stepping the all should be well
Of course a lot depends on how you have configured the stepper driver microstepping
Good luck