You are not logged in.
Pages: 1
Hi,
I recently installed nanodlp in a brand new raspberry pi 4, to replace an old raspberry 2 that broke.
With the new raspberry 4 I am not able to project light with the projector.
Do I have to write any code before trying to use the projector?
What steps do you follow once you have a 'brand new' nanodlp to set it up.
Thanks!
Offline
It is usually not difficult, if resolution is not detected correctly (tvservice -s on ssh terminal can help you) you should define it on config.txt.
Offline
What should I define on config.txt?
You mean the file on the SD of the raspberry right?
Offline
I have seen in the config.txt you can delete de # of certain lines to add them to the code.
Maybe trying to delete the one referring to the HDMI?
Right now I have it ''original''-new, what do you recommend to change / add.
Offline
if the tvservice report wrong resolution, remove all HDMI/framebuffer related ones. If it is not working correctly after removal, add correct resolution manually by using HDMI group and etc.
Offline
Pages: 1