You are not logged in.

#1 2016-11-17 16:22:03

sgraber
Member
From: Indiana
Registered: 2016-03-11
Posts: 54
Website

Add Feed Rate to Z Calibration buttons

Hi!  Would it be possible to add feed rate gcode to the Z-calibration buttons on the Calibration tab?  A couple of us running GRBL have problems with the Z- up/down buttons not functioning.  Adding something like F200 to the gcode would fix this for us.  smile

Offline

#2 2016-11-17 20:50:55

Shahin
Administrator
Registered: 2016-02-17
Posts: 3,536

Re: Add Feed Rate to Z Calibration buttons

z-axis calibration page need some serious update. I will try to come up with ways to make it more useful.

Offline

#3 2016-11-25 10:54:17

Shahin
Administrator
Registered: 2016-02-17
Posts: 3,536

Re: Add Feed Rate to Z Calibration buttons

I have add it, it called "Manual Movement Gcode Template" on beta version setup page.
Default value is "G1 Z[[Position]]", you can customize it as you wish.

Offline

Board footer

Powered by FluxBB