nanoDLP

c_sharper

Member

Registered: 2020-09-20

Posts: 7

Anyone tried to use NanoDLP on a Creality LD-001

I recently bought a second hand Creality LD-001. To see if resin printing is something for me.

After upgrading to the latest firmware the machine just print for 5 minutes and then nothing. I can't find any good firmware out there.

It is running a Raspberry Pi 3 if I am correct. So I thought there might be a better piece of software. I see people using the Wanhoa with NanoDLP. So I was wondering is it possible to run NanoDLP with the Creality?

c_sharper

Member

Registered: 2020-09-20

Posts: 7

Re: Anyone tried to use NanoDLP on a Creality LD-001

I managed to open the machine. Shutter en z-axis control is done using usb. I can identify annusb to serial chip, but that's it. It has an atmega chip on it. I would upload an image if I knew how

c_sharper

Member

Registered: 2020-09-20

Posts: 7

Re: Anyone tried to use NanoDLP on a Creality LD-001

I guess that could be for sending gcode?

c_sharper

Member

Registered: 2020-09-20

Posts: 7

Re: Anyone tried to use NanoDLP on a Creality LD-001

I managed to get z-axis moving. The settings weren't saved because the xy resolution wasn't set when I changed to ramps serial port to ttyusb0.

M106 lights on
M107 lights off
G1 ZXXXX all work

I can't seem to make the lcd screen work. No images are shown. Anyone an idea?