nanoDLP

F.m

Member

Registered: 2017-12-22

Posts: 147

adjustable Antialiasing

dear Shahin, AA feature is usable in big build area or low resolution projectors, as there is thin pipes as low as 0.25 mm in jewel cad files, current AA settings makes these pipes thinner because of big pixel sizes and it causes print failure. is it possible to make it adjustable as is in creationworkshop?

or is there any way to apply nanodlp mask to other slicer PNG file?
or is there any way to add something like Z-suit "overgrowth correction" in which manually add or remove some pixels from model outer perimeter?

Last edited by F.m (2020-05-22 20:52:37)

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: adjustable Antialiasing

1. You can use erode feature. It is not possible to modify as it backed deep into rendering algorithm.
2. Using PNG format you can modify each pixel intensity not sure what kind of alternative you need.
3. It sounds similar to erode feature