nanoDLP

figarojewelery

Member

Registered: 2020-05-18

Posts: 2

RASPBERRY PI 3 MODEL A+

Hello. will the board work with nanodlp ?
RASPBERRY PI 3 MODEL A+

Specifications
SoC: Broadcom BCM2837B0 64-bit, Cortex-A53 @ 1.4GHz
RAM: 512MB LPDDR2
VideoCore IV GPU
Built-in dual-band Wi-Fi (2.4GHz / 5GHz) IEEE 802.11 b / g / n / ac standard (Cypress CYW43455 chip)
Built-in Bluetooth 4.2 LE (Cypress CYW43455 chip)
MicroSD card slot
USB 2.0 x 1
Full Size HDMI Connector
Composite 3.5 jack for audio / video output
40 pins GPIO
Interface for connecting a CSI camera
Interface for connecting a DSI display
Power 5V 2.4A via microUSB connector.

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: RASPBERRY PI 3 MODEL A+

Any raspberry pi version will works.
Also you can use any arm board too but with correct nanodlp build.

figarojewelery

Member

Registered: 2020-05-18

Posts: 2

Re: RASPBERRY PI 3 MODEL A+

Any raspberry pi version will works.
Also you can use any arm board too but with correct nanodlp build.

RAM: 512MB LPDDR2  not too small?

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: RASPBERRY PI 3 MODEL A+

Depend on file size, only slicing and 3D previous takes lots of RAM. For other functionalities 50MB will be more than enough.