nanoDLP

Sacha

Member

From: Belgrade- Serbia

Registered: 2016-08-26

Posts: 19

Website

HDMI

I would like to ask how to turn off lamp after print is finish on Dell 7609WU DLP printer. I have both RS232 and HDMI both type A and B, and I have set Raspberry Pi to  shut down projector after part is finish, but it seams that I'm sending wrong command. Currently I have connect RPi with HDMI cable only.  Any Help from Support ?

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: HDMI

You need to find command necessary to turn off your projector from the manual. Turning off projector through HDMI require certain protocol supports which rarely you could see on current projectors.