You are not logged in.

#1 2020-03-04 07:49:35

Xemerius
Member
Registered: 2020-03-04
Posts: 3

Fysetc Nanodlp shield V1.1 Vref points

Hello i am trying to build up a printer with direct control via raspberry. For this i use a Fysetc Nanodlp shield V1.1. Can anyone tell me where to find the Vref test point for the stepper driver on this shield. Until now (in other projects) i used stepper driver seperatly with defined points in combination with the potentiometer to get the Vref. Which points do i have to use on this shield?

Offline

#2 2020-03-04 10:22:51

bigfilsing
Member
Registered: 2016-11-20
Posts: 306

Re: Fysetc Nanodlp shield V1.1 Vref points

typically the adjustment screw "carries" Vref
So black probe to ground and red probe the adjustment screw.

Offline

#3 2020-03-04 10:40:19

Xemerius
Member
Registered: 2020-03-04
Posts: 3

Re: Fysetc Nanodlp shield V1.1 Vref points

Thanks for the reply. Sounds logical. I will give it a try later. I wasnt sure whether i can use the ground of the 12V shields input or not.

Offline

#4 2020-03-04 11:04:32

bigfilsing
Member
Registered: 2016-11-20
Posts: 306

Re: Fysetc Nanodlp shield V1.1 Vref points

Ground should be common to both the Raspi and the shield.

Offline

#5 2020-03-04 17:46:48

Xemerius
Member
Registered: 2020-03-04
Posts: 3

Re: Fysetc Nanodlp shield V1.1 Vref points

Everything works fine. Thank you again.

Offline

Board footer

Powered by FluxBB