You are not logged in.
Pages: 1
After upgrading to version 2546, the printer stopped working.
I have on my printer "Shield Axis Direction" = "Zero at Top" and "Z-Axis Height" = 176800
The zero sensor is located at the top of the printer.
Before updating, printing of the first layer began from a height of 221 mm, and after updating from 0 mm
Can you bring back the old logic of work?
Can you add a rollback function to a previous version?
Offline
After changing “Shield Axis Direction” to “Zero at bottom”, the first layer is also printed from 0 mm
Offline
Please, let me know the last version that worked for you.
Offline
generic:2454 is good working
Last edited by somik (2020-01-29 20:52:47)
Offline
So it is working but from wrong position, right?
Is it working with direct control or RAMP?
Offline
Works through RAMPS but the first layer with Z0 instead of Z221
Offline
What about other layers? increase from 0 or it get corrected on layer 2?
Please, also share a debug file.
Offline
on other layers too wrong. I’ll attach the debug file later
Offline
Launched printing in version 2454 - printing went right with Z220.96
Then it was updated to 2559 and restarted printing - printing began with Z0.04 - this is wrong
Offline
Bugfixed, will push new version online next week. Thank you for the report.
Offline
Pages: 1