You are not logged in.
Pages: 1
Hi Shahin,
I seem to be running into an issue with nanosupport. Each time it slices the file, it is placing it at an angle. It's a thin piece and this makes it have overhangs and improper slices. I have tried several programs to ensure that the file is actually laying flat on the bed.
As viewed, you can see that one image only has 1/2 the print, the next has an over hang, the last two present only part of what should be one layer.
I tried:
solidworks
cura
stomp
nanosupport
is there an easy way to have nano support orient it flat (I tried orientation) as well as translation windows.
Thanks!
Offline
Here is the PDF with an additional slide showing I cannot orient the part flat - tried at 0.1 degree increments.
Last edited by elliot (2020-01-14 18:08:12)
Offline
Add this as bug report for nanosupport.
Offline
Pages: 1