You are not logged in.
One problem my team is having is that the error 500 code is perpetually displayed within the NanoDLP software. The secondary/related problem is that the manual movement commands of the printer work, but no commands are being sent to the printer upon the beginning of a new print. The print will slice and begin, showing the print progress, but the printer itself will simply not move. The light source functions as expected (cycles through the slices) while the printer stays at its original position.
Offline
1. Provide screenshot of the page error being displayed in
2. It is firmware synchronization issue. You need compatible firmware to have sync with nanodlp. Without it you should use delay instead of WaitForDoneMessage on gcode boxes.
Offline