nanoDLP

colgeocol

Member

Registered: 2016-09-14

Posts: 23

Direct Control PCB Bill of Materials

Shahin,

I downloaded the direct control PCB Eagle files and I have some questions.

Is the picture of the direct control PCB on top of your Raspberry Pi the rev1 version?  It just doesn't look like the rev2 data.  If it is the rev1 PCB could you also post a picture of the rev2 PCB?

Could somebody supply the complete Bill of Materials information, preferably as a .XYRS file?  This would have the orientation information needed by a PCB manufacturer who will also populate it.

I plan to use this board with a dual output 5/24vdc power supply and my Raspberry Pi 3 for a top down design.  Do you recommend using NEMA-17 or NEMA-23?

Any information would be appreciated.

Thank you.

Shahin

Administrator

Registered: 2016-02-17

Posts: 3,541

Re: Direct Control PCB Bill of Materials

We become to busy lately so I guess we could not prepare it any time soon. But if somebody else do that I would happily host it.
PCB designed for rpi 2 and 3.
Nema-17 is more than enough. Weaker motor prevent possible mistakes. For example it could not break your VAT if it goes too low.