You are not logged in.
Hello, I have a fresh installation from SD image build 2418. My setup is Rpi3, Mega2560 and DLP projector. Everything works fine except one odd behavior. There are a small green icon at the upper right corner of the displayed image. The green icon is flashing for 2-3 seconds, then disappear for a few seconds, then again is on. It is no matter if the printer is projecting sliced image or is IDLE. It is not from the projector settings, because the same is happened with different projector - I have two and made a test with the second one. This green icon looks like at the attached picture.
Offline
It is probably low voltage indicator.
Offline
Thanks Shahin.
Offline