You are not logged in.
Pages: 1
Hello!
I installed a very powerful UV LED with power control on my printer. Cure Time for almost all polymers does not exceed 1-2 seconds. At the same time, wait before time became very important, because in 1-2 seconds, the polymer does not have time to spread. Also on the base layers, the average power of the LED is very important. Now the Wait Before Print time begins at the moment the LED is turned on, and in vain heats the LCD matrix. It is necessary to control separately the power of the LED for the base layers and ordinary layers.
Please add in the Resin Profile the ability to replace the Shutter Open Code and Shutter Close Code commands, separately for the base layer and separately for the main one.
Offline
You can already do so using conditional.
Offline
And how to make conditions in the settings?
Have instructions?
Offline
I would like to make different settings for Shutter Open Code for different profiles.
I have the ability to control the UV-LED brightness using the Snnn command and there are resins for which Cure Time is power independent. For such plastics, it is necessary to reduce the brightness in order to avoid overheating
Offline
Why you are not using before and after layer print?
Offline
Pages: 1