You are not logged in.
When you click on the printer off button on the main screen -
The message Could not connect to the NanoDLP is displayed. Please check your network connection.
The printer behaves as if it rebooted. After 1 min, the printer again displays the message Could not connect to the NanoDLP. Please check your network connection.
After it, the printer can be turned off.
Offline
Could you try the latest beta as there are some difference on shutdown procedure.
Offline
In version 2591, the problem repeated.
When you press the "Power Off" button, the printer restarts, and after a minute it turns off
Offline
Probably just app get restarted before complete shutdown, doubt it is os restart then shutdown as there is nothing on nanodlp side which could resume shutdown operation
Offline
It looks like NanoDLP restarts and shutdown is done after 1 min
Offline
If you connect to the printer via SSH and then press the "Power Off" button in nanodlp, then the line will immediately appear in the terminal:
Broadcast message from root @ 3D-Som-SLA-03 (Tue 2020-03-03 00:00:14 MSK):
The system is going down for poweroff at Tue 2020-03-03 00:01:14 MSK!
NanoDLP restarts immediately, and then the Raspberry Pi shuts down.
Offline
I have the same symptoms. I'm using Building 2615, and when I press the shutdown button, it turns off and reboots right away.
Offline